arduino

By JonathanGuthrie, 29 May, 2016

Well, I had not one but two bad potentiometers, and there were three customizations I needed to make to the software for the keyer to work the way I expected, but I've got the speed control working and all of the memory buttons working and the two different PTT lines working.

What isn't working? Well, I destroyed one of the buttons when I recabled it, so I need another momentary contact switch. I don't know if I'll replace it. I mean, 11 memories is almost exactly as good as 12, right? I'm never going to use them all, after all.

By JonathanGuthrie, 23 May, 2016

At long last, I have a memory keyer. It was about four years ago, as near as I can tell, that it occurred to me that, not only was constructing a memory keyer based upon the Arduino a good idea, that it was sufficiently obvious that someone else must have done it already. That meant I could leverage their code and hardware designs to that end. After I found K3NG's design and and software, I decided that this project would make a good introduction to PC Board layout and good practice for surface-mount construction.

By JonathanGuthrie, 20 August, 2014

Okay, I wired up the I2C interface to the LCD, connected the potentiometer for the speed control, and connected jacks for the key and the key out. Along the way, I found that I had labelled the I2C lines wrong, swapping the data and clock lines.

And, yesterday I created a keying cable to go between the keyer and the FT-102, and the radio keyed! So, I need to put it in a box.

By JonathanGuthrie, 31 July, 2014

I survived ApolloCon just fine, and I'm more energetic than I can remember being, so I have started to work on projects again. I have too many projects, but I still want my memory keyer to be finished, so I'm working on that.

A while back, I finished the board layout for the correct transistor pinouts, and I sent it off to OSHPark to be turned into actual boards. I also ordered parts. Last week I even found out what was wrong with my soldering iron (it wasn't set up right at the factory) and I fixed it. So, I was all set.

By JonathanGuthrie, 16 May, 2014

I have two updates from previous posts. First, Mal just called and said my FT-102 is ready. The problem appears to have been a bad 10 MHz crystal reference oscillator. It wasn't putting out enough signal so the phase comparator wasn't working so the PLL wasn't locking up. I should get the radio back in a week or two, I just have to (gladly!) pay for the repair.

By JonathanGuthrie, 11 May, 2014

I've wanted a memory keyer for a long time, but they tend to be expensive and I don't work enough CW to really justify it. However, about three years ago it occurred to me that you could make a memory keyer out of an Arduino. (An Arduino is an amazingly cheap microcontroller board that some clever Italians designed. See, e.g. http://www.arduino.cc/ for more information.) Anyway, a while after I thought of that, I decided that I didn't want to spend a bunch of time designing the hardware and programming the Arduino.