Submitted by JonathanGuthrie on Tue, 02/02/2021 - 21:11
I've been working toward this for a while. Since I last visited the keyer project, I rearranged my workbench so my work area is larger. My computer, which used to share half the table of the workbench now covers the entire table, and I got my microscope out and went a little nuts with the surface-mount parts. Having finished that, there was no reason not to put the through-hole parts on the board, either. And now, well, a picture is worth 1000 words, right? One of the red LED's doesn't light, and I don't know why, but there will be time to figure that out later.
Submitted by JonathanGuthrie on Thu, 10/08/2020 - 09:25
UPDATED
A couple of years ago, I wote about a new keyer I was working on. What I meant by "working on" at that point was the software. I got a ways into that project and then essentially no farther. Life intervened and I got interested in other things and ran into some issues that I couldn't immediately overcome and a dozen other wimped-out excuses. So, it might come as a shock, assuming that there's anyone left who is paying attention, that I've not only continued to work on this project, but have actually made progress.